All 74 values recorded for this model, as the source lists them and in its units. The spec sheet shows the same data checked, typed and converted.
Overview
Production
Manufacturer
Farmall (a part of International Harvester)
(no label)
Built in Louisville, Kentucky, USA
(no label)
The Cub featured IH's "Cultivision" offset engine and steering. Three major series of the original Cub were built: the Farmall Cub until 1964 (sn 224703), the International Cub until 1975 (sn 248124), and the new International Cub until the end of production in 1979.
Engine
(no label)
International Harvester 1.0L 4-cyl gasoline
Transmission
(no label)
3-speed sliding gear
Power
Drawbar (claimed)
10 hp | 7.5 kW
PTO (claimed)
11 hp | 8.2 kW
Belt (claimed)
9.76 hp | 7.3 kW
Plows
1 (12 inch)
Drawbar (tested)
9.87 hp | 7.4 kW
Belt (tested)
10.39 hp | 7.7 kW
Mechanical
(no label)
Two-wheel drive
Steering
manual
(no label)
Differential contracting band brakes
(no label)
Open operator station.
Capacity
Fuel
7.5 gal | 28.4 L
Hydraulic system
0.56 gal | 2.1 L
Hydraulics
Capacity
0.56 gal | 2.1 L
Pressure
1200 psi | 82.7 bar
Total flow
2.8 gpm | 10.6 lpm
Hitch
Type
IH Fast Hitch
Pto
Rear PTO
independent
Rear PTO Type
Cub-10 (0.9375)
Engine RPM
-1800@1800
Dimensions
Wheelbase
69.25 inches | 175 cm
Weight
1477 to 1877 pounds
Front tire
4.00-12
Rear tire
8-24
Serial location
(no label)
Serial number plate on the right side of the Farmall Cub, above the front axle.